window ac price in India

It has been demonstrated through numerous studies that filters that are not cleaned or left neglected can cause more or less severe illnesses such as a sore throat, bronchitis, abdominal pain, colds, lumbago, bacterial infections and other diseases affecting the respiratory system.

The maintenance of the air conditioner is an operation as important as necessary to improve its energy efficiency and to avoid the risk of filling our rooms with unhealthy air.

Here the cleaning of the air conditioning filter becomes indispensable as it avoids the onset of pathologies and problems to the plant itself. Themain task of Intec air conditioner is to purify and refresh the air in the house in which it is installed, as well as being able to filter dust and bacteria present in it.

The primary cleaning of air conditioners should be done at the end of the season, around September / October, to prevent dust and dirt from getting encrusted in the appliance during the winter season. And to extend his life, it would be good to protect him, in the winter months, with a suitable cover.

In any case, during the summer use, it is necessary to perform some main operations:

• Cleaning of the outdoor unit and, if possible, of the internal one, constantly subjected to dust and pollutants (on this occasion we also check the stability of the engine support);
• Cleaning the filters, where germs and bacteria are easily lurking;
• Verification of possible refrigerant gas leaks and condenser control.

Do you need a technician for these operations? To clean the engine and the filters, it is not necessary to contact a technician, but we can do it ourselves.

The cleaning of the units

However, if we do not have the time or opportunity to do so, we will contact a window air conditioner brands in India that installs air conditioners that will ask about 40 euros (VAT excluded) for the internal and external cleaning of the appliance, plus the cost of specific products used.

If, on the other hand, we clean the engine, make sure that the appliance is switched off, and proceed to remove the protection grid.

With a simple brush, we can remove the dust accumulated on the blades, which we will then wash with a wet cloth and a universal degreaser.

If we notice that there are some obstacles, even just the dry leaves that can obstruct the engine, we use the vacuum cleaner to remove it: we will allow the correct operation of the appliance over time and will avoid producing annoying noises.

If the motor is housed in a hard-to-reach place, cleaning will require the use of the compressor and a ladder or scaffolding, and it would be better, in this case, to call a technician who will carry out the work in safety.

Where the air conditioner should be placed?

Refrigeration equipment should be placed in places where there is not too much sun and where there is good air circulation. This must be fulfilled with both the outdoor and indoor units.

How can you optimize consumption?

What should be done to avoid unnecessary consumption is to turn off the air conditioning when there is no one in the place where it is located. Many climate control equipment already includes energy saving mechanisms.

At what temperature should the AC be programmed?

The normal and recommended temperature, taking care of the environment, usually oscillate between 22 and 25 degrees centigrade. If the humidity increases, the temperature should be reduced so as not to modify the thermal sensation.

It must be taken into a report that a temperature that differs by more than 12 degrees from the outside temperature should not be programmed since this will increase the energy consumption by 8% for each degree that exceeds those twelve degrees of difference.

How is the ideal temperature achieved?

It is essential that since the window air conditioner brand in India is turned on, it is programmed to the desired temperature. Neither higher nor lower. Nor should the temperature be set higher or lower than what we want to cool or heat faster. This can be achieved with the ‘powerful’ mode that almost Continue reading →